chanelink logo
CHANELINK
Nederlands

Preview and output do not match SVG

Categorieën:
Laser
678
2
Bekijk vertaling
03-04

My svg looks good on the workspace and node edit mode looks good but preview has gaps in the path and actual output matches preview.

laser

I have redone the shapes and at first it looked good until I did the preview after moving it to Upper left corner.
What should I check?

I have gone back and now find that the loss occured when I put the output on layer 2. The output and preview look good on all layers except layer two. Very puzzling.
C

    • Jamie

      03-05
      Make sure that tabs are off
      Bekijk vertaling
      Antwoord

    • Keegan

      03-06
      It is possible when you selected the lines for assigning them to CO2, you might have missed some of them.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren