chanelink logo
CHANELINK
Nederlands

There is a problem sending data to the laser

Categorieën:
Laser
633
1
Bekijk vertaling
2024-12-05
Hello,
I also have the problem that when transferring data I get the error message that an error occurred while sending (the device may be busy or stopped).
In the forum I found a post that you can try to set "enable DTR signal" in the device settings.
Where exactly can I select this in the device settings?
C

    • JOST

      2024-12-06
      Here’s where the enable DTR signal is located in device settings.
      Bekijk vertaling
      Antwoord
    Relevante aanbevelingen
    Verzamel
    Rapporteren