chanelink logo
CHANELINK
Nederlands

XY zero point, but the object is at the edge of the workspace

Categorieën:
Laser
905
1
Bekijk vertaling
2024-09-30

Hello,
Normally when i whant the object in the home corner for starting to laser
i do X=0 and Y=0
When i do it now the object is crossing the edge of the machine workspace
en the object reverence looks like its lining from the object middle

in the picture you see the XY are zero, but the allining from the black object is crossing the workspace

laser
C

    • Aaron

      2024-10-03
      Your anchor point is set to bottom center. It needs to be bottom left to get the results you want.
      Bekijk vertaling
      Antwoord
    Relevante aanbevelingen
    Verzamel
    Rapporteren