chanelink logo
CHANELINK
Nederlands

Lines don’t stay together when I “trim line”

Categorieën:
Laser
Tags:
179
1
Bekijk vertaling
2023-11-28

I intend to cut two lines to transform the two areas into one. When I do “trim line” the line n stays in one. Then it creates open part problems. Does anyone know a way to not have to see each zone to manually join these points that don’t stay together?

LightBurn

LightBurn

LightBurn
C

    • roy

      2023-11-29
      Just grab the line end point (the green square) and drag it to another one that you want to connect it with. LightBurn has no idea what you intend by trimming, so it doesn’t automatically join things back up.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren