chanelink logo
CHANELINK
Nederlands

No connection Lightburn with Comgo Z1

Categorieën:
Laser
Tags:
371
1
Bekijk vertaling
2023-11-03

It works fine with Laser GRBL but not with LB. Can’t find the Com Port. Again, Com 3 on GRBL and no issue - instant connection.
C

    • John Trant

      2023-11-06
      What happens if you select COM3 in LB? You can’t be connected via LaserGRBL at the same time.
Don’t use automatic laser discovery, add the laser manually as “grbl” device. Then connect to COM3.
If this has been done already, try toggling the “enable DTR signal” setting in device settings.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren