Why does LB break up lines into 2mm segments in gcode?
Categorieën:
Laser
1K
1
0
2023-07-05
C
John Trant
2023-07-06Assuming you don’t have perforation mode or tabs/bridges on I assume this is due to a setting on Smoothieware devices. Check if you have “Reduce Smoothieware pause delay” enabled. Disable this and retest to see if that changes the behavior.
0Antwoord
Relevante aanbevelingen
-
Vertical text creation
1 Antwoord2024-01-16 -
Cut the triangle again instead of the square
5 Antwoorden2024-11-28 -
Lightburn automation
1 Antwoord2024-01-04 - 2024-09-25
-
Come attivare i comandi M10 e M11 per laser
1 Antwoord2023-05-30
