chanelink logo
CHANELINK
Nederlands

Multi setting in lightburn

Categorieën:
Laser
Tags:
1K
1
Bekijk vertaling
2023-07-05

I bought a file on Etsy, when I import it into lightburn I get the following setting (see photo) how do I set this properly so that the laser will engrave and cut
Greetings Ronald
C

    • Robert Evans

      2023-07-06
      Double Click on the entry in the Cuts/Layers Section, and it will bring up the Cut Settings Editor. This will show the different layers within the Multi layer as seen here: Select each part to edit the attached settings.
      Bekijk vertaling
      Antwoord
    Relevante aanbevelingen
    Verzamel
    Rapporteren