chanelink logo
CHANELINK
Nederlands

Cutting a slit in MDF with LM3

Categorieën:
Láser
Tags:
965
1
Bekijk vertaling
2023-06-19

Hey all,

First time poster but long time reader! Have just gotten my new Laser Master 3 but still to fire it up as builing my set up. Lm3 has a 10w laser midule and gave air assist by way of the external Ortur compressor.

I’m wanting to cut a slit in 12mm MDF to use as part of my waste board. Technically doesnt need to be a cut out but does need to be at least 6mm deep. Slit will be 3mm wide.

I’m not 100% sure the laser will cut through it but wondering what anyone’s thought were on engraving the slit? Or best to cut the whole slit out (if ot can)?

Cheers,

Steph
C

    • Williams

      2023-06-20
      "cut a slit in 12mm MDF"
Rather than vaporize all that MDF, slice the board with a saw, then glue the two pieces together with a strip of of 3 mm MDF standing on edge at the bottom to form the slot. Cut the strip to whatever width makes the slot the proper depth.

This depends on being able to saw-cut straight paths, a trick I generally got right using a radial-arm saw, Doing it by hand poses a definite challenge.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren