chanelink logo
CHANELINK
Nederlands

Fill is wobbly while Line looks good?

Categorieën:
Laser
Tags:
796
1
Bekijk vertaling
2023-06-14

Hi,
I’m a newbie to the laser world so I’m hoping some can help me understand what I’m doing wrong. Basically when I use line, the vector image I am using is turning out fine, but as soon as I switch to fill, the engraving is wobbling at random points. I’m using same speed/power settings (1000/80 )on my Sculpfun 10W diode laser Please see attached picture. Has someone else faced this problem?
C

    • Christian

      2023-06-15
      It looks like your laser is losing position as it makes scanning movements, but not Line movements. Check to make sure your belts are tight - particularly in the dimension your laser is losing position in (that is probably ‘X’, or the left-to-right dimension).

If that doesn’t help, try reducing the speed at which you’re running your Fills at. Sometimes a particular combination of speed and acceleration can reduce mechanical resonance, leading to the effect you’re seeing.
        Bekijk vertaling
        Antwoord
      Relevante aanbevelingen
      Verzamel
      Rapporteren