How do I organize this vertically and horizontally

Williams

Categorieën:

Laser

Tags:

LightBurn

994

Bekijk vertaling

2023-06-05

I’m working on a guitar fretboard. Usually the fret dots go in the middle of the fret board, which is easy to figure out in lightburn. But for this particular board I want the fret dots to be dead center on the left half between the edge of the fretboard and the center line. And also dead center between the two frets. Any ideas?

Payson

2023-06-06

Create the temporary geometry you need, snap the circle to the center of it, and delete the geometry. An X from the two corners of the area in which the Dot is to be centered, should do.
Yes?

Bekijk vertaling

Antwoord

Relevante aanbevelingen