Z-axis does not move upward during homing

That’s defined in the firmware. There is no setting to change this from the outside. You would need a new firmware then (at least if Atomstack didn’t invent a new firmware setting to configure that).

You could try this at your own risk. Works for dlc32 controller.
The command to turn on this feature: ($Homing/Cycle1=Z)or($Homing/Cycle0=Z;$Homing/Cycle1=XY)
The command to turn off this feature: $Homing/Cycle1=0

• 55455rml

  : I assume I type this in the console and it will then be a permanent part of the gcode for the machine? As I am sure you can tell this is new to me so I appreciate your help.

• Henry

  답글

  @55455rml

  : I don’t know what controller you have. For the dlc32 I had the Z was disabled and entering $homing/cycle0=z and then $homing/cycle1=xy enabled the Z axis during homing.

• 55455rml

  답글

  @Henry

  : I tried putting these in the console and in the start gcode/end gcode under the gcode tab of device settings and it didn’t change anything.