Raytools BM110 Autofocus - A axis reset fail

check if the limit switch is PNP or not. our controller only support NPN type.
Mostly this error happend when the limit switch can not be found

• Juan Barkhuizen

  : There is no issue with the Limit switches, they show up in Diagnoses and doing homing or axis reset gives no errors. I can see the autofocus move when I reset it, It goes from 0 to -15 then resets back to zero. This issue happens each time I switch the machine on, it asks me if the machine is reset, then it gives this error after that. Manual move works, and software control also works no issues. I am not sure why I get this error still