chanelink logo
CHANELINK
한국어

See power at a given point in grayscale

카테고리:
Λέιζερ
태그:
377
2
번역 보기
2024-01-11

Hello everyone,
I’m trying to engrave using grayscale mode, I have a hard time figuring out which part is at full power, which part are in a small power.
Is there a way to see the power it will engrave at a given point before launching the engraving ?
Regards.
C

    • Cyril

      2024-01-12
      If you enable “Shade according to power” in Preview, it will show you the relative power differences in the engraving based on grayscale value. However, I don’t believe this shows you the absolute power level that will be used to engrave after translation to Max and Min power levels.
        번역 보기
        답글

      • jay

        2024-01-22
        goods?
          번역 보기
          답글
        관련 추천 사항
        수집
        보고서