chanelink logo
CHANELINK
한국어

TwoTrees TTS-55 Connection Issues with Lighburn GRBL

카테고리:
원자 램프
태그:
798
1
번역 보기
2023-10-31

Hello Guys,

i’am new in the laser business and i’m trying to connect my Two Trees TTS-55 with the Lighburn Software, but it is’nt successful.

I’m getting this out of the console, but i don’t know what that means:

Waiting for connection…
Waiting for connection…
Waiting for connection…
[MSG:Local access point Laser_ started, 192.168.4.1]
[MSG:HTTP Started]
[MSG:TELNET Started 8080]
[MSG:‘$H’|‘$X’ to unlock]
Grbl 1.1 [‘$’ for help]
Your Grbl may not support Variable Power mode (M4)
If your laser does not turn off between cuts,
switch to the GRBL-M3 device
[MSG:‘$H’|‘$X’ to unlock]
[MSG:Caution: Unlocked]
Waiting for connection…
124
load:0x40080400,len:5856
entry 0x400806a8

When i connect the Laser with LaserGRBL everything works fine. The Baudrate is set to 115200 and thats the same as in LaserGRBL.
There is a .lbset with configuration for the TTS, but i dont know how to load it.
Is there anybody who can help me?
Thanks a lot.
C

    • Darren

      2023-11-01
      To me the output looks more like a firmware issue, but then LaserGRBL also shouldn’t be able to connect successfully. Can you move the laser using LaserGRBL?
While tackling another problem, we found a solution to change the “enable DTR signal” option in device settings to make the connection work properly. You might try this as well.
        번역 보기
        답글
      관련 추천 사항
      수집
      보고서