chanelink logo
CHANELINK
한국어

Laser window not popping up

카테고리:
원자 램프
태그:
766
1
번역 보기
2023-10-12

Good day, I recently purchased the sculpfun s6pro I got it to produce once about a week ago now today when I set up the program all the windows seem to pop up EXCEPT the laser window to control the machine, what I am I missing or doing wrong, also I try using the homing button and it tells me “ homing cycle not enable in GRBL settings “ is this something I’ll have to do every time? As you can tell I am very new to this hobby.
C

    • Abel

      2023-10-13
      Homing Cycle Not Enabled is an error that stems from how your firmware is set up on your laser. Does your laser have limit switches - I don’t believe the S6 pro does from the factory, which means if you enabled ‘Auto-home on startup’ during LightBurn’s device setup, that error would be produced.

You can disable homing on startup by going to ‘Edit > Device Settings’ and disabling the switch on the right hand side of the window, as below.
      번역 보기
      답글
    관련 추천 사항
    수집
    보고서