Engrave Settings, Suggestions?

I see you’re dithering, which is a great approach for these.
A couple of things to try… Let’s get the dark, darker… :slight_smile:
If you dissolve some baking soda into water and spray your wood first, then let it dry, the engraving usually comes out a lot darker. It’ll be less likely to warp if you spray both sides.
Because dithering dots are full-on or full-off and because human eyes are not, you have to pull the dark side down, and reduce the contrast a little, to get the middle ranges back.
Hover over the image, right click and select ‘Adjust Image’.