chanelink logo
CHANELINK
한국어

Ender 3 laser don’t start

카테고리:
원자 램프
태그:
721
1
번역 보기
2023-04-20

Hi all!
I have just built a laser module on my Ender 3 printer by using the fan port.
Now everything seems to work, manual put on and off the laser by command M106 works perfect.
But when executing a generated G-code, the laser will not get switched on.
I think the problem is that the wrong command is given by the Lightburn software but I can not find the setting…
Also the homing button does not work, it will give a message Unknown command $H.
Setup is:
Laser : GRBL-M3 (1.1e or earlyer)
Hope you can help me out!
C

    • Marshall

      2023-04-21
      Try various baud rates and toggling “Enable DTR signal” to see if you can get it to connect. Make sure you’re on the right Port in Laser window.

In Edit->Device Settings there’s an option for “Pointer offset”. Configure there.
        번역 보기
        답글
      관련 추천 사항
      수집
      보고서