Just installed ruida 6442 and control is always reseting 10000mm x 10000mm y and I can't figure it out for the life of me
2022-12-281.1K10It is always impossible to cut through. Finally, it has to be cut twice, and the effect is not good. How to adjust it?
2023-01-0991510It is useless to set a fixed point, no matter how many times you set a fixed point, or start cutting from the same position.
2023-01-0681610The border running is normal, but the click to start does not respond.
2023-01-0693310I am not familiar with the software, how to set the starting point and direction of cutting?
2023-01-051.1K10During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.
2022-12-3083211Switch to the manual state, press the Z+and Z - buttons on the operation panel, and the Z-axis motor will not move.
2022-12-301.2K21When pressing Z - or Z+for a longer time (about 3-4S), the Z axis will go down or up all the time, and it is normal to press Z - or Z+for a shorter time.
2022-12-3099510After cross cutting correction, the cross cutting is not aligned, and there is still offset.
2022-12-2487910The panel did not prompt hard limit protection when Z-axis reached the hard limit switch.
2022-12-2494110When the RDC6442S is operated, the graphics super format is automatically divided. The laser first cuts in the X direction and then does not emit light. The U axis starts to feed materials to a certain length, and then the laser cutting stops. (Automatic blocking does not work)
2022-12-2497710Press Z-axis to move manually on the panel, and the cutting head does not move
2022-12-2398310
- 데이터 없음
한국어
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski
