Does anyone know?
2023-01-091.1K10I am not familiar with the software, how to set the starting point and direction of cutting?
2023-01-051.2K1001Ensure the normal operation of the laserTry to ensure that the ambient temperature is not lower than 5 ℃, so as to meet the normal operating conditions of the laser, and avoid causing failures or affecting the stability of the laser performance. Avoid the laser water cooler from freezing at low temperature.1. The recommended method to prevent ...
2022-12-261.2K11Influence of galvanometer frequency of laser derusting motor on laser
2023-01-0697810Can someone tell me how to operate it?
2023-01-0689710How to check the quality of metal laser cutting? See the following nine standards.1. RoughnessThe laser cutting section will form vertical lines. The depth of the lines determines the roughness of the cutting surface. The shallower the lines, the smoother the cutting section. Roughness not only affects the appearance of edges, but also affe...
2023-01-0498300During power on and reset, the X axis stopped after touching the limit switch, while the Y axis was still running slowly at the origin.
2022-12-3094111Switch to the manual state, press the Z+and Z - buttons on the operation panel, and the Z-axis motor will not move.
2022-12-301.3K21When pressing Z - or Z+for a longer time (about 3-4S), the Z axis will go down or up all the time, and it is normal to press Z - or Z+for a shorter time.
2022-12-301.1K10After cross cutting correction, the cross cutting is not aligned, and there is still offset.
2022-12-241K10The panel did not prompt hard limit protection when Z-axis reached the hard limit switch.
2022-12-241K101. Controller: used to generate track points, i.e. expected output.2. Driver: It is used to convert the control signal (usually speed or torque signal) from the motion controller into a current or voltage signal of higher power and output it to the actuator.3. Actuator: such as hydraulic pump, cylinder, linear actuator or motor, used to output mo...
2022-12-2692411When the RDC6442S is operated, the graphics super format is automatically divided. The laser first cuts in the X direction and then does not emit light. The U axis starts to feed materials to a certain length, and then the laser cutting stops. (Automatic blocking does not work)
2022-12-241.1K10
- 데이터 없음
한국어
- English
- 简体中文
- 繁体中文
- Français
- Русский
- Italiano
- 日本語
- 한국어
- Português
- Deutsch
- Español
- Türkçe
- Ελληνικά
- Nederlands
- Tiếng Việt
- Polski