chanelink logo
CHANELINK
日本語

After upgrading the rolylaser from 10W to 20W, the laser will not return to the homepage

カテゴリ:
Laser
226
2
翻訳を見る
2024-11-20
after installing a 20W upgrade laser from the 10W, laser will go to orgin, frame but when homing to the proper left hand cornner it makes a huge grinding noise. I tried the manual method but still have the same results.
C

    • Aaron

      2024-11-21
      Is the new laser head engaging the limit switches? They may need to be adjusted.
        翻訳を見る
        返信

      • Liam

        2024-11-22
        Is that 20w module a lot bigger? You need to move 1, or both, limit switches to keep from hitting the frame. Start with the Yaxis switch first.
          翻訳を見る
          返信
        関連する推奨事項
        収集
        報告