chanelink logo
CHANELINK
日本語

Lightburn vs LaserGRBL

カテゴリ:
レーザ
タグ:
687
1
翻訳を見る
2024-01-04

I’m making jigsaw puzzles using a Atomstack A5 Pro. When using LaserGRBL I can cut my material at 100% 500 mm/min 4 passes. When using the same settings in Lightburn it is nowhere near cut. Is there some other setting I’m missing? The only difference I see is that LaserGRBL passes the entire drawing 4 times where Lightburn passes each line 4 times.
C

    • Terrelle

      2024-01-05
      It sounds like your S Value Max may be set to 255 in LightBurn. Most GRBL lasers nowadays use a range of 1-1000 for the S value (power setting).
Please go to ‘Edit > Device Settings’ in LightBurn and see if this is the case. It’s in the lower right corner of that page:
      翻訳を見る
      返信
    関連する推奨事項
    収集
    報告