RDCutist

Cityslicker

カテゴリ:

Ruida

554

翻訳を見る

2023-11-15

Do you need to actiuvate RDcutist software to use it ?

blue sea

2023-11-15

Hello,The use of our RDcutist software requires the encryption program to work normally, you can contact the equipment manufacturer or business personnel to obtain the relevant encryption program information. Thank you for your support and love for our products!

翻訳を見る

返信

Cityslicker

: Is that encryption for RDC6563FG ?

blue sea

2023-11-20

Yes, the motherboard software program is encrypted and requires a matching unlocker to use. Just contact the equipment manufacturer to provide it.

翻訳を見る

返信

RDCutist

VCutWork - Nesting mode

Once powered on, the cutting head will always move upward, and will not stop. Switch to the manual state, and the motor can be controlled to move, and then switch to the automatic mode, and always mov

Press the test key ".", the cutting head is in the following state, but the jitter is large.

When operating RDC6442S, an error occurred after the automatic blocking of the graphic super format was selected.

The lifting is not good