chanelink logo
CHANELINK
日本語

Settings for neje 4max

カテゴリ:
レーザ
タグ:
866
1
翻訳を見る
2023-08-24

If I try to start the laser He always Go Up first and than start .
So he runs against the switch and lost the steps he need. look pic.

Can Anyone Help me whit this
C

    • Tory

      2023-08-25
      What are you expecting to happen?
I suspect you have either a material height set or a Z-offset configured on your layer.
If you want no movement then trying the following:
1. In Edit->Device Settings enable “Relative Z Moves Only”
2. Remote any Z-offset in Cut Settings
        翻訳を見る
        返信
      関連する推奨事項
      収集
      報告