chanelink logo
CHANELINK
日本語

Increasing line width on SVG cut?

カテゴリ:
レーザ
タグ:
769
1
翻訳を見る
2023-06-25

When using an SVG file to engrave, is there any way to increase the width of the cut? LightBurn seems to ignore the stroke width setting in the SVG file.

If I export the SVG as a PNG file, then LightBurn respects the stroke width, but the PNG takes 10x longer to engrave, since is has to scan the workpiece along all rows and columns, whereas the SVG engraves quickly, since it’s just following the paths.
C

    • roy

      2023-06-26
      There is a workaround that works for me. If I want to increase the line thickness when engraving a vector file I will use the offset tool. If you set the offset to “both” & set your offset to half your preferred line thickness. You will need the activate the switch to delete the original line.
        翻訳を見る
        返信
      関連する推奨事項
      収集
      報告