RDC6445G Tri-color Lamp

Keith23

カテゴリ:

Ruida

460

翻訳を見る

2023-06-07

Hi all,

I've just completed building a 600mm x 400mm 90w machine with an RDC6445G controller.

I noticed (in the manual) that a tri-color warning lamp can be connected to the controller but I'm unsure how to do this. I did see a video on YouTube where a single lamp was connected to the 'Status' pin but I would like a three-color lamp (as shown in the manual). How does this connect to the controller?

blue sea

2023-06-08

Hello, you can connect the STA port to the green light, the OUT1 port to the yellow light, the OUT2 port to the red light to connect, thank you for your support of Ruida products!

翻訳を見る

返信

RDC6445G Tri-color Lamp

Using V8 software, in user parameters, cutting parameters and idle acceleration are invalid after they are changed,how to solve?

Why is the image reversed on the Ruida controller？

The lifting is not good

RDC6563FG mit Alpha5 Servo

After cutting, it is found that the graphics in the software and the actual graphics are reversed from left to right or up to down.