chanelink logo
CHANELINK
日本語

Going from engrave to cut and using air assist

カテゴリ:
Laser
タグ:
889
1
翻訳を見る
2023-06-07

Hi All
Newbie question
How to engrave something then cut around it in lightburn using air assist. As I understand it AA is best used for cutting only. If you’ve only got something like aquarium air pump is there a way to pause lightburn from starting the cut till your ready. This is for a diode laser.
I know on Sculpfun S30 it’s done automatically thru software.
Hopefully this makes sense.
Cheers Geoff
C

    • Vasili

      2023-06-08
      I highly recommend leaving AA on all the time. Otherwise, your lens will get dirty and break fast. AA is a great lens protection function.
If you want to automatically control the AA, you can add a relay to most boards
        翻訳を見る
        返信
      関連する推奨事項
      収集
      報告