chanelink logo
CHANELINK
日本語

How do I organize this vertically and horizontally

カテゴリ:
レーザ
タグ:
1.2K
1
翻訳を見る
2023-06-05

I’m working on a guitar fretboard. Usually the fret dots go in the middle of the fret board, which is easy to figure out in lightburn. But for this particular board I want the fret dots to be dead center on the left half between the edge of the fretboard and the center line. And also dead center between the two frets. Any ideas?
C

    • Payson

      2023-06-06
      Create the temporary geometry you need, snap the circle to the center of it, and delete the geometry. An X from the two corners of the area in which the Dot is to be centered, should do.
Yes?
      翻訳を見る
      返信
    関連する推奨事項
    収集
    報告