chanelink logo
CHANELINK
日本語

Help with engraving Images

カテゴリ:
レーザ
タグ:
909
1
翻訳を見る
2023-05-26

I cannot get lightburn to engrave an image. If I use GRBL it will engrave no problem. In lightburn I get a gcode error. Any help would be great. Thanks, Dave
C

    • Jamie

      2023-05-27
      G90
; GCode clustering enabled (max 8)
G4 P1
M4

Some engravers do not have ‘clustering’.

Click Edit, then click Device Settings… Turn off the ‘Enable GCode Clustering’ switch… Then Carefully click ok at the bottom. We really want to make sure the setting stays put.
      翻訳を見る
      返信
    関連する推奨事項
    収集
    報告