chanelink logo
CHANELINK
Italiano

Laser cutting of acrylic with rough edges

Categorie:
Laser
Tag:
350
1
Vedi traduzione
09-29
Hello, I am cutting extruded acrylic and the edges are very rough and appear to have little bubbles through out it. I've cut this stuff before with a great flame polished finish. Any advice on why this is happening?
C

    • Williams

      09-30
      Have you tried lowering the amount of air assist you are using? Too much and it will cool the cutting zone.
        Vedi traduzione
        Rispondi
      Raccomandazioni pertinenti
      Raccogli
      Segnala