chanelink logo
CHANELINK
Italiano

RDC6563FG

Categorie:
Ruida
1K
5
Vedi traduzione
02-26
Hello.
I have RDC 6563FG, laser MAX 1500, BM-110 head and two X-Y axes.
I need to place the metal plate at a distance of more than 30 mm from the nozzle and process it with a defocused laser beam.
Is it possible to disable the use of the capacitive sensor and not monitor the gap between the metal plate and the nozzle? Otherwise, the message appears - <too small cap>.
C

    • blue sea

      02-28
      Hello! You can choose not to follow in the layer settings to disable it.
        Vedi traduzione
        Rispondi

      • A56F72A7

        02-28
        In this case, the graphics are processed without turning on the laser radiation.
          Vedi traduzione
          Rispondi

        • A56F72A7

          03-04
          The issue is resolved. The shutter had to be pressed before the start
            Vedi traduzione
            Rispondi

          • A56F72A7

            03-06
            One more question. Why is the "Machine Check" button not active in RdCutist v3.0?
              Vedi traduzione
              Rispondi
              • blue sea

                : Hello, this function is not yet open for use, the software is constantly being tested and optimized, please pay attention to the latest notice on our official website in the future, thank you for your support and use!

            Raccomandazioni pertinenti
            Raccogli
            Segnala