chanelink logo
CHANELINK
Italiano

Rotating problem roller clamp

Categorie:
Láser
779
4
Vedi traduzione
02-10
Switched from rollers to chuck and now the image/texts are reversed. Did I miss a setting somewhere. Are they different from using the rollers to the chuck? Xtool D1 Pro 20W with RA2 Rotary. Any advice appreciated.
C

    • Darren

      02-11
      Most of these are two phase motors. There is no standard which phase goes where. It’s likely that you can just move the pins and change which phase is which.
The other option is to make a pigtail that swaps the wires there.
      Vedi traduzione
      Rispondi

    • Marshall

      02-12
      Hi
      Vedi traduzione
      Rispondi
      • Darren

        : Yep, you can do that too

      • James
        Rispondi
        @Darren

        : Thanks for the insight. I saw that, I’ll try that. Thanks again.

    Raccomandazioni pertinenti
    Raccogli
    Segnala