chanelink logo
CHANELINK
Italiano

Generate error gcode when enabling rotation

Categorie:
Laser
628
3
Vedi traduzione
2024-10-18

when I create a flat project it generates x and y and perfect central position.
if you activate the rotating roller or spindle, the positions are significantly staggered.
then the dimensions are significantly altered as is the starting point on the y axis.
It’s not a roller configuration problem but a problem that I can’t understand the cause of.

It is clear that I expected a variation in the size of the y axis based on the variation in the cm traveled in the rotation, but this is not the case
Thank you

laser
C

    • John Trant

      2024-10-21
      That depends on the setting of the $102 parameter. If you changed it for the rotary, you will have to change it back. I admit yours is a big difference. Did you check the $101 parameter?
        Vedi traduzione
        Rispondi
        • Jack Wilborn

          : No grbl code I use marlin. In may opinion the problem is bug in lightburn. Do the tests and see that there is a problem with the program. just look at the data generated by the program, it is not a machine setting

        • John Trant
          Rispondi
          @Jack Wilborn

          : I did, before I replied. I set the steps in the Rotary window to 60 where it should have been 80 and the Yaxis travel was les than it should have been. I generated GCode for both Rotary off and on to see what would happen. Using a chuck or rollers makes a difference too. The numbers you posted suggest a roller rotary. No idea how you can fix it on a Marlin controller.

      Raccomandazioni pertinenti
      Raccogli
      Segnala