chanelink logo
CHANELINK
Italiano

Air Assist stopped working

Categorie:
Laser
741
2
Vedi traduzione
2024-09-23
Can anyone help with auto air assist, I upgraded motherboard Atom stack to allow auto air on/off, it worked perfectly untill the last Light burn update, the on/off button in the cuts/layers is set ot on, is there something in the background that needs setting.
C

    • Kevin

      2024-09-24
      It is most likely the air pump went bad, the power supply for the pump went bad, or the connector came loose. Not a software problem.
        Vedi traduzione
        Rispondi

      • Gilbert

        2024-09-25
        You need to set up the correct M Value in Lightburn. It is either M07 or M08. It is somewhere in the settings of Lightburn. To test it, just type in the console window M07 or M08 and check which one activates it. M09 switches it off again.
          Vedi traduzione
          Rispondi
        Raccomandazioni pertinenti
        Raccogli
        Segnala