chanelink logo
CHANELINK
Italiano

Multi setting in lightburn

Categorie:
Laser
Tag:
607
1
Vedi traduzione
2023-07-05

I bought a file on Etsy, when I import it into lightburn I get the following setting (see photo) how do I set this properly so that the laser will engrave and cut
Greetings Ronald
C

    • Robert Evans

      2023-07-06
      Double Click on the entry in the Cuts/Layers Section, and it will bring up the Cut Settings Editor. This will show the different layers within the Multi layer as seen here: Select each part to edit the attached settings.
      Vedi traduzione
      Rispondi
    Raccomandazioni pertinenti
    Raccogli
    Segnala