chanelink logo
CHANELINK
Italiano

Setting Starting Point

Categorie:
激光
Tag:
941
1
Vedi traduzione
2023-07-05

I’d like to cut out these two tree shapes using a perforated cut. I want to hide the “skip” spots under the tree branches where they are not so visible, since they stand out against the charring of the rest of the perimeter cut.

How do I specify the starting point so I can set a distance that places the “skip” spots where I want them?
C

    • Robert Evans

      2023-07-06
      LightBurn has a Tabs and Bridges tool built into the Cuts Settings Editor.
You want manual control of where the line is not engraved? Select Manual under Tab Generation.
      Vedi traduzione
      Rispondi
    Raccomandazioni pertinenti
    Raccogli
    Segnala