Job origin not lining up

Payson

Categorie:

Laser

Tag:

LightBurn

815

Vedi traduzione

2023-06-25

I just noticed on my most recent file, that the job origin is somehow not lined up to to only visible vector.
I use to be able to have the control over where the job orientation was. now, it is offset from the job current vectors. I am able to delete all other layers and it would then move to the remaining layer position.
Any thoughts.
Ver 1.4.00 and been using Lightburn regularly for last 2 yrs. I was fairly confident in it.

Jen

2023-06-26

Origin position will be affected by all shapes in your design irrespective of whether or not they are visible.
You could work around that by using “Cut selected graphics” and “Use selection origin”.

Vedi traduzione

Rispondi

Raccomandazioni pertinenti