chanelink logo
CHANELINK
Italiano

OmTech Polar Exhaust fan controlled by Air Assist?

Categorie:
Laser
Tag:
973
2
Vedi traduzione
2023-06-02

I have the OmTech Polar and it seems the exhaust fan is controlled by the air assist setting. Is there a way to change this? I would like the exhaust fan to run anytime the laser is working, and not be tied to the air assist setting.
C

    • Jamie

      2023-06-05
      There are a couple of outputs used by most of us with a Ruida.
When active the Status output sinks current. It becomes active anytime you run a job… The Wind sink, is active when a layer with air assist is enable and executed…
      Vedi traduzione
      Rispondi
      • Jamie

        : I don’t know how your fan is wired… I ran mine through a ssr from Amazon 1 to the Status pin…

    Raccomandazioni pertinenti
    Raccogli
    Segnala