Creality Falcon 2 40W laser - which version of LightBurn do I need to run it?

roy

Categorie:

Laser

Tag:

LightBurn

960

Vedi traduzione

2023-06-02

Just ordered the Creality Falcon 2 40W laser. What version of Lightburn do I need to connect to it? I do not know the type of controller inside it. I assume the exiting Falcon 2’s with 22W use the same software. Any advice will be greatly appreciated.

Tory

2023-06-05

I have the Creality CR-Laser Falcon (the first one, 10 W), and on the memory card they provide, there was some files. Under Software > LightBurn, there was a version of LB (obsolete, just download the latest version from here), a PDF file with instructions, and a CR-Laser Falcon.lbdev file which, if I recall correctly, you can load into LB to get the proper settings for this hardware.
I guess you must have something similar for your model.
And most of these files can be downloaded from the Creality site too.

Vedi traduzione

Rispondi

Raccomandazioni pertinenti