chanelink logo
CHANELINK
Italiano

Help with finding the center of a workpiece

Categorie:
Laser
Tag:
954
1
Vedi traduzione
2023-05-16

I have lasered and cut out a plaque approx 3x5" - I want to turn it over and burn a word on the back, but I want to do it in vertically in the center of the board. I am using a atomstack a20 pro - for the life of me I cannot figure out how to center the diode to the center of the board. When I frame the word the diode goes to the left of the board instead of printing vertically at center. Can anyone help me - Please and thank you DISREGARD THE OPTION REGARDING A CAMERA
C

    • Clarence

      2023-05-17
      You can select USER ORIGIN and change CURRENT POSITION to center in LB, then set your plaque on the workspace, move the laser head to the exact center of the plaque and frame to see if it is correct. In LB you should see a green square on the workspace in the middle of your engraving. This should do the trick!
        Vedi traduzione
        Rispondi
      Raccomandazioni pertinenti
      Raccogli
      Segnala