Need help with the fill option

Kevin

Categorie:

激光

Tag:

LightBurn

979

Vedi traduzione

2023-05-05

I am attempting to create an image that has a filled in area, with unfilled circles. I attempted to use “line” on the circles, but it doesn’t recognize them and fills the areas in anyways. Suggestions?

Miller

2023-05-06

Move the circles and perimeter to the same layer. Areas that overlap within the same layer will be become negative space.

Vedi traduzione

Rispondi

Raccomandazioni pertinenti

Segui

Raccogli

Segnala

Need help with the fill option

Application analysis of air compressor in laser cutting field

Beixing and Jeep have entered into strategic cooperation to accelerate the mass production of the front lidar of the vehicle

The Science Island team has made new progress in the Faraday rotation spectrum NOx two-component synchronous detection

Researchers have constructed a laser with a size of only 300 nanometers that can generate green light at room temperature for the first time.

Peking University has successfully prepared high-quality perovskite submicron single crystal material to realize continuous optical pumping laser source