Controller won’t load a file once its a saved file

Gilbert

Categorie:

Laser

Tag:

LightBurn

526

Vedi traduzione

2023-04-11

Once I make a lightburn file, my laser won’t load it. I hit send and it shows the loading of the file sending but the laser won’t accept it, it seems. Now if I open a new file and copy paste the same cut or engraving on the new file before saving it, hit send the laser accepts it just fine. I just updated to the newest LB version hoping that would clear the issue but it didn’t. I currently have to open a saved LB file, copy the layers and then open a new file and paste then hit send before the laser will accept it.

Jen

2023-04-12

Then very possibly a too full controller situation.
You can try deleting them from LightBurn. Go to File List and delete files in the list. If the Window is not visible then enable it in Windows menu.
If that doesn’t work, you can do this directly from the Control Panel on the laser in the File management screens. How you get there will depend on your specific controller.

Vedi traduzione

Rispondi

Raccomandazioni pertinenti