Français

Progress in research on neodymium doped strontium aluminate lanthanum magnesium laser crystals by Shanghai Optics and Machinery Institute

909
2024-04-17 16:11:47
Voir la traduction

Recently, the Advanced Laser and Optoelectronic Functional Materials Department of the Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, has made progress in the research of Nd: ASL (Sr0.7Nd0.05La0.25Mg0.3Al22.7O19) laser crystals, and the related achievements were published in Infrared Physics&Technology under the title of "Tunable laser operations on Nd doped continuum and lanthanum aluminum crystals".

Neodymium (Nd3+) ion is one of the common activating ions, and its absorption peak matches the emission wavelength of commercial laser diodes (LDs), with high absorption efficiency at 0.9, 1.05, and 1.35 μ There are emission peaks at position m, and laser emission has been achieved in various matrix materials. Nd: ASL is a typical disordered crystal, belonging to the hexagonal crystal system. The high disorder leads to its spectral broadening, which is beneficial for generating lasers of different wavelengths.

In order to investigate its tuning characteristics, the research team grew Nd: ASL crystals with a doping concentration of 5%, and measured their fluorescence lifetime to be approximately 371.8 μ S. At 1.05 μ Near m, its fluorescence spectrum has four strong and continuous emission spectra. A birefringent filter was inserted into the V-shaped resonant cavity for tunable laser experiments. By using output mirrors with transmittance of 5%, 7%, and 10%, three independent wavelengths (1050, 1062, and 1074 nm) of laser output were obtained. The wavelength range is 1049.59-1054.43 nm and 1059.71-1078.18 nm for tuning, with a tuning width greater than 20 nm, which is consistent with the spectrum. The phenomenon of multi wavelength laser output was also observed in the experiment. The results indicate that Nd: ASL crystals are a gain medium suitable for tunable lasers. Compared with single wavelength laser media, controlling and changing the wavelength is much more convenient and suitable for complex application scenarios with higher accuracy or more wavelengths.

This work has received support from projects such as the National Natural Science Foundation of China.

Figure 1. Fluorescence spectrum of Nd: ASL crystal

Figure 2. Laser output with three wavelengths at different output mirror transmittance

Figure 3. Output power at different wavelengths under the same absorption pump power

Source: Shanghai Institute of Optics and Precision Machinery

Recommandations associées
  • Optical Capture of Optical Nanoparticles: Fundamentals and Applications

    A new article published in Optoelectronic Science reviews the basic principles and applications of optical capture of optical nanoparticles. Optical nanoparticles are one of the key elements in photonics. They can not only perform optical imaging on various systems, but also serve as highly sensitive remote sensors.Recently, the success of optical tweezers in separating and manipulating individual...

    2023-11-25
    Voir la traduction
  • China University of Science and Technology proposes composite cold field 3D printing technology for liquid crystal elastomers

    Recently, Associate Professor Li Mujun from the School of Engineering Sciences and the Institute of Humanoid Robotics at the University of Science and Technology of China, together with researchers such as Professor Zhang Shiwu, has made significant progress in the field of intelligent material 3D printing. The research team proposed composite cold field 3D printing technology and successfully pre...

    02-25
    Voir la traduction
  • The United States promotes the development of next-generation EUV lithography technology

    LLNL has long been a pioneer in the development of EUV lithography technology.A laboratory located in California will lay the foundation for the next development of extreme ultraviolet (EUV) lithography technology. The project is led by Lawrence Livermore National Laboratory (LLNL) and aims to promote the next development of EUV lithography technology, centered around the laboratory's developed dr...

    01-06
    Voir la traduction
  • Researchers have proposed a new idea for quasi particle driven ultra bright light sources, which can be used in various applications from non-destructive imaging to chip manufacturing

    An international team of scientists is rethinking the fundamental principles of radiation physics, aiming to create ultra bright light sources. In a new study published in Nature Photonics, researchers from the Higher Institute of Technology in Lisbon, Portugal, the University of Rochester, the University of California, Los Angeles, and the Optical Applications Laboratory in France proposed the us...

    2023-10-24
    Voir la traduction
  • Van's updates the manufacturer of laser-cut parts

    Van's Aircraft has responded to reports of ruptured dented parts found in AirVenture's latest kit. These defects are caused by external suppliers changing the process of laser cutting parts. From February 2022 to June 2023, Van's moved some parts from traditional punch manufacturing to an outside supplier that can laser cut rivet holes. The move is designed to increase the company's throughput and...

    2023-08-04
    Voir la traduction