chanelink logo
CHANELINK
Français

My engraving machine moves in one direction, how can I set it up?

Catégories:
Ruida
1.3K
2
Voir la traduction
05-27
I am a novice, I tried to use an engraving machine to carve some patterns, but I found that the engraving machine did not carve in the correct direction of the pattern, but in the wrong direction. How can I change the setting? I use RDWorksV8 software
C

    • 96DED7E9

      05-27
      Check in Config --- Settings that the print head position is not Mirrored
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport