chanelink logo
CHANELINK
Français

The camera suddenly deviates from the "Y" axis

Catégories:
Laser
708
2
Voir la traduction
02-11
What would suddenly cause the camera to be about 2 inches off in the Y axis? I was using the camera for a few cuts to salvage some scrap and it was working perfectly as usual then from one set up to the next, it framed two inches higher in the Y axis than showed in the picture, There were no bumps or shocks to the lid or cabinet, the alignment was just suddenly off, The cam mount is tight and seemingly unmoved.
C

    • Vasili

      02-12
      Might be a bug or lost settings. Try to reload the backup settings from before. Or do the calibration again and make sure to save the configuration files then.
        Voir la traduction
        Répondre
        • Iron Man

          : It’s all good now, I re-aligned the camera and it is once again spot-on

      Recommandations pertinentes
      Collecter
      Rapport