chanelink logo
CHANELINK
Français

Rotating problem roller clamp

Catégories:
Laser
226
4
Voir la traduction
02-10
Switched from rollers to chuck and now the image/texts are reversed. Did I miss a setting somewhere. Are they different from using the rollers to the chuck? Xtool D1 Pro 20W with RA2 Rotary. Any advice appreciated.
C

    • Darren

      02-11
      Most of these are two phase motors. There is no standard which phase goes where. It’s likely that you can just move the pins and change which phase is which.
The other option is to make a pigtail that swaps the wires there.
      Voir la traduction
      Répondre

    • Marshall

      02-12
      Hi
      Voir la traduction
      Répondre
      • Darren

        : Yep, you can do that too

      • James
        Répondre
        @Darren

        : Thanks for the insight. I saw that, I’ll try that. Thanks again.

    Recommandations pertinentes
    Collecter
    Rapport