Rotating image distortion
Catégories:
Laser
471
2
0
2024-11-01
C
jessie
2024-11-04Measure your engraved output and compare with design dimensions (to see if the problem is X or Y). Also test correct flat output by designing 1 squares with 50mm side and 1 with 100mm then engrave in a piece of cardboard and check dimensions.
0Répondre-
: Hello, thank you for your reply. Flat, don't worry, the odds are good When rotating, I measured according to your requirements and found that the Y-axis is too large compared to the drawing (at 33.7 mm for light burning and 45 mm for real)
-
Recommandations pertinentes
-
How does laser cladding work
0 Réponses2022-08-08 - 2023-03-04
-
Tomwisdom and rotary
1 Réponse2023-03-23 -
3D scanner enables new ideas to come true
0 Réponses2022-10-28