chanelink logo
CHANELINK
Français

How to change the slot depth to 2.6 millimeters?

Catégories:
Laser
684
2
Voir la traduction
2024-09-09
I downloaded a file from etsy and it has a ton of tabs and slots that are designed for 3mm wood. I have 2.6 mm wood and have changed the slot width for all pieces except the sides. In the screen shot the slot depth circled is 3MM and I need them to be 2.6MM. Is there a way to simply manually change the length to 2.6mm? I have already gone into node editing mode and do not see extra segments. The lines are all solid if that makes sense.
LightBurn
C

    • Gilbert

      2024-09-10
      You are trying to change slots on an edge that has tabs, if you visualize a line from corner to and they protrude past the line they are tabs if they are below ( into panel ) they are slots.
        Voir la traduction
        Répondre
        • Darren

          : I found my issue. Seems there were nodes that I could only see if I zoomed in at max range. I deleted the node to the right and the slots resize now. thanks

      Recommandations pertinentes
      Collecter
      Rapport