chanelink logo
CHANELINK
Français

Lightburn vs LaserGRBL

Catégories:
Laser
Tags:
690
1
Voir la traduction
2024-01-04

I’m making jigsaw puzzles using a Atomstack A5 Pro. When using LaserGRBL I can cut my material at 100% 500 mm/min 4 passes. When using the same settings in Lightburn it is nowhere near cut. Is there some other setting I’m missing? The only difference I see is that LaserGRBL passes the entire drawing 4 times where Lightburn passes each line 4 times.
C

    • Terrelle

      2024-01-05
      It sounds like your S Value Max may be set to 255 in LightBurn. Most GRBL lasers nowadays use a range of 1-1000 for the S value (power setting).
Please go to ‘Edit > Device Settings’ in LightBurn and see if this is the case. It’s in the lower right corner of that page:
      Voir la traduction
      Répondre
    Recommandations pertinentes
    Collecter
    Rapport