chanelink logo
CHANELINK
Français

Added the Ortur Extension but it doesn’t Frame

Catégories:
Laser
Tags:
644
1
Voir la traduction
2023-12-26

Hello all. I hooked up my Ortur Extension to engrave longer pieces and changed my settings but when I hit Frame the laser goes to about the middle right of the project and just stops. Any suggestions? Seems to be only this particular project.

LightBurn
C

    • Nugent

      2023-12-27
      You likely didn’t extend the Y-axis Max Travel GRBL configuration ($131).
Go to Edit->Machine Settings and adjust $131 to your new Y height.
        Voir la traduction
        Répondre
      Recommandations pertinentes
      Collecter
      Rapport