Ruida RDACC-Fiber-V2.0

Gewindestange

Catégories:

Ruida

705

Voir la traduction

2023-12-12

Hello dear Ruida team,

i got the Ruida RDACC Fiber Module V2.0 from you.

I activated the calibration menu during the dry running test.

Here the voltage was displayed to me and then the module switches after two seconds and then displayed 0 volts.

Because i didn't understand it at first, i confirmed the 0 Volt value by pressing Enter. Now the module can no longer pulse due to incorrect calibration.

I can do whatever i want, the module always shows me 0 Volts in the second step in the calibration menu.

The voltage specification from the first step is not adopted.

Is there a different procedure or an update for the fiber module?

Attached a photo from the two menu images in the calibration menu. I would be happy if I got an answer :)

Greetings from germany

Michael

blue sea

2023-12-12

Hello! Please log in to https://www.rdacs.com/en/download?id=84&m=manual&a=RDAcc-fiberV2.0 to download the operation manual of the corresponding product, and follow the instructions in the manual to set up and operate. There is no latest update.

Voir la traduction

Répondre

Gewindestange

2023-12-12

Hi blue sea,
thanks for your answer :)
I have read this guide and worked from it. I'll sit down again at the weekend and check everything.

Have a nice day
Michael

Voir la traduction

Répondre

Gewindestange

2023-12-29

Hi together.

I tested it with several 644x controllers, I tested it with a 6332G.

It's always the same. The module notices that I press the Pulse button in the calibration menu, the voltage is displayed, the display switches after 2 seconds and shows me 0.00 volts.

I can no longer use the module :(

Voir la traduction

Répondre